There are two ways to install the column of pvc lawn guardrail: expansion screw fixation and embedded fixation. Here are two ways to fix the PVC plastic steel guardrail column.

1. The column of the PVC lawn guardrail fixed by expansion screws should be welded to the empty square bottom plate at the bottom of the column reinforced steel according to the requirements of the installation position, and the iron parts of the bottom plate should be fixed with expansion screws;

 
2. For buried fixation, a 300-35mm square pit should be dug at the fixed position of the column, put into the pit according to the pre-embedded depth, and then poured into concrete to fix it. In fact, the manufacturer here recommends the pre-embedded method. Because of this method, there is no need to use some requirements for fixing with expansion screws. The column is directly dry in the empty square bottom plate. If it is the method of spraying the screw, if there is any installation problem, the guardrail will be fixed at a certain level. It is not so easy to solve the problem of installing it to a certain extent. We still recommend the pvc lawn guardrail the most, because this guardrail leaves a few more Semi-Privacy Fence surfaces in the air after it is finished, and gets lost. The beautiful rural guardrail is directly above the installation example, and the most important step is to repair the exposed part of the column foundation into the shape of a scattered water slope of about 5°, so as to facilitate the flow of rainwater. During the installation process of the column, it must be marked with a spirit level to ensure that the column is vertical. And the columns are on the same line and the height is the same. Well, the columns of the pvc lawn guardrail are installed in this way. We should focus on the pre-buried type in our daily life.

The full name of PVC lawn guardrail is guardrail; it is called "plastic steel", but the only disadvantage of plastic steel is its poor rigidity. Therefore, when assembling the structure, the plastic-steel structural parts are lined with steel as reinforcing ribs according to the wind load requirements to make up for its deficiencies, so it is called a hardness guardrail. We think this is unreasonable to add plastic steel guardrail, please pay attention to all these points.